Wood Finishes
Vankote Spray Conversion Varnish

Type
Vinyl Alkyd Melamine

Coverage
Approximately 300 sq.ft./gallon, depending on the condition of the surface.

Application
This product may be applied by spray only.

Reduction
Spray - As needed with T-199 Vankote Reducer

Dry time
Handle - 30 Minutes
Sand - 30 Minutes
Recoat - Must be recoated in 4 hours to minimize lifting

Cleanup
Use MIBK

Warning!
Removing existing paint from surfaces by means of sanding, scraping, or other mechanical means may create dust or particles containing lead. Avoid creating dust or other debris. BREATHING OR EATING LEAD-CONTAINING DUST OR DEBRIS CAN CAUSE HEALTH PROBLEMS, ESPECIALLY FOR CHILDREN AND PREGNANT WOMEN.

Special properties
Vankote is a multi-resin synthetic finish which cures by reaction with a catalyst. Vankote is typically applied by spray with conventional air, airless, air-assisted or HVLP technique and then air or forced-air dried. It provides an exceptionally chemical resistant finish which meets or exceeds all Kitchen Cabinet Manufacturers Association specification.

Where to use
Vankote is ideal for new cabinets, furniture, and woodwork finishing where the surface can be sprayed and where chemical resistance is desired.

Surface preparation
Surface preparation is a key factor in proper finishing. The surface must be clean, dry, and free of dirt, grease, and mildew. Fill holes and cracks with paste wood filler. Sand wood before applying Vankote.

Application
Apply only when the air temperature and that of the surface to be stained are above 50 degrees F. Stir thoroughly before using. Apply a full even coat by spray. Sand lightly between coats with fine sandpaper. This product must be catalyzed with C-1 Catalyst before using.

Colors available
V800-25 Satin Vankote
V800-55 Gloss Vankote

Package sizes
Gallons

Primers
Exterior Paints
Interior Paints
Wood Finishes
Specialty Coatings

Back to Products page